Data Sheet: 640N Data Sheet (PDF)
Diagram: 640N Detailed Diagram (PDF)
   
 

 

The AMPTEC 640N Failsafe Ohmmeter

The 640N failsafe igniter tester is a ruggedized, water-resistant, portable and has been specifically designed for ultra-safe resistance testing on explosive devices (i.e. Tomahawk Cruise Missile, ESSM squibs, igniters, flares, rocket motor squibs, detonators).  The 640N case is water proof when closed to a depth of 3 feet.  The 640N also floats in water. It can be operated outside in direct rain, as it has silicon rubber boot seals over all switches.  It also features a high level 2.0 MegaOhm range to facilitate "isolated" electrical resistance measurements.

Floats in Water

Failsafe Design - Built-in Can't Fail Life Saving Features

There are a variety of critical military, aerospace, and industrial applications which utilize squibs and other blasting devices.  In each case, it is extremely important that these devices detonate when required.  It is equally important that these devices do not detonate while being tested for coil integrity.  To this end, AMPTEC equips each instrument with redundant, dual fail-safe current limiting resistor network circuitry to ensure that the instrument test currents cannot exceed the specified amount.  Even in the unlikely event of a worst case component failure, the output current limiting network is still in effect.

Naval Ordnance Approved for the ESSM and Standard Missile

The US Naval Ordinance Center Safety Board has approved the AMPTEC 640N for use on the ESSM and NAVY Standard missile.  The 640N safety features and design make it ideal for a variety of electronic explosive device verification requirements (EEDs).  The limited access (one use at a time) external connection port on the 640N also makes it physically impossible to simultaneously connect the AC/DC Charger while measuring with the test leads.  Whether charging the Ni-CAD batteries or measuring a squib’s resistance, there is only one connection port, it's a case of "either/or" but never both.  The 640N operator can connect the AC/DC Battery Charger to the 640N limited access connection port for recharging the Ni-CAD Batteries thus mechanically blocking access for the measuring sense leads. When measuring, using the sense leads, the same limited access connection port then blocks any battery charger connection.  Contact the Sales department at AMPTEC RESEARCH for a copy of the NAVY Ordnance Safety Board Approval.

Faraday Cage provides Electronic Noise Immunity, EMP and Static protection

The 640N electronics are encased in a shielded Faraday cage (all to chassis ground) to provide additional electronic noise immunity, Electromagnetic Pulse (EMP), and electrostatic discharge (ESD) protection.  AMPTEC RESEARCH's design and manufacturing engineers have over 36 years of experience in the manufacture of Igniter Testers.  Give us a call, and let our experienced test engineers work with you on any ordnance test application.

Verify the AMPTEC 640N milliampere current output - Onboard milliammeter and Test resistors

The AMPTEC 640N Igniter tester comes with a SIMPSON™ DC millammeter built into the 640N Function Test Section. The built-in analog milliammeter measures the 640N test current and spans from 0 to 10 millamperes fullscale. This lets the 640N user truly verify that the 640N test current is at "SAFE" levels, just prior to measuring squib resistance.  See the 640N diagram below for a more a more detailed view of the function test section and the test resistors. 

Specs:
Accuracy: (180 days 25°C ± 10°C) ± 0.02% of reading  ± 0.02% of range for 20 ohm through 200 Kohm ranges. 1.0% of reading  ± 0.2% of range for 2.0 Megohm range.
Display:

4½ digit (19999) L.E.D.  - 20,000 counts
Display visible in direct sunlight (5 times brighter than high intensity LEDs)

Terminal Configuration:

Four-wire Kelvin

Four Resistance Ranges: 20.0 Ohm, 200.0 Ohm, 200 KOhm, 2.0 MegaOhm
Overload Indication:

Display flashes

Maximum Input:

250 VDC or peak AC without damage

Operating Temperature Range

0°C to 50°C

Temperature Coefficient ±.002% per °C (from 0°C to 15°C and 35°C to 50°C)
Conversion Rate

Approximately 3 per second

Power:

Rechargable Ni-Cad batteries (5.0 Ahr) & Charger (115 VAC 50-60 Hz)

Size: 295mm/11.5" D x 335mm/13.5" W x 155mm/6" H
Weight

12 lbs NET - 15 lbs shipping

 

 

Home - About Us - Products - Instant Quote - FAQ - Tech Library - Shipping - Credit App
email AMPTEC